8fb577ae6d
This change addresses two distinct scenarios which are possible when performing a sequential resilver to a dRAID pool with vdevs that contain silent unknown damage. Which in this circumstance took the form of the devices being intentionally overwritten with zeros. However, it could also result from a device returning incorrect data while a sequential resilver was in progress. Scenario 1) A sequential resilver is performed while all of the dRAID vdevs are ONLINE and there is silent damage present on the vdev being resilvered. In this case, nothing will be repaired by vdev_raidz_io_done_reconstruct_known_missing() because rc->rc_error isn't set on any of the raid columns. To address this vdev_draid_io_start_read() has been updated to always mark the resilvering column as ESTALE for sequential resilver IO. Scenario 2) Multiple columns contain silent damage for the same block and a sequential resilver is performed. In this case it's impossible to generate the correct data from parity unless all of the damaged columns are being sequentially resilvered (and thus only good data is used to generate parity). This is as expected and there's nothing which can be done about it. However, we need to be careful not to make to situation worse. Since we can't verify the data is actually good without a checksum, we must only repair the devices which are being sequentially resilvered. Otherwise, an incorrect repair to a device which previously contained good data could effectively lock in the damage and make reconstruction impossible. A check for this was added to vdev_raidz_io_done_verified() along with a new test case. Lastly, this change updates the redundancy_draid_spare1 and redundancy_draid_spare3 test cases to be more representative of normal dRAID replacement operation. Specifically, what we care about is that the scrub run after a sequential resilver does not find additional blocks which need repair. This would indicate the sequential resilver failed to rebuild a section of one of the devices. Note also the tests were switched to using the verify_pool() function which still checks for checksum errors. Reviewed-by: Mark Maybee <mark.maybee@delphix.com> Signed-off-by: Brian Behlendorf <behlendorf1@llnl.gov> Closes #12061 |
||
|---|---|---|
| .github | ||
| cmd | ||
| config | ||
| contrib | ||
| etc | ||
| include | ||
| lib | ||
| man | ||
| module | ||
| rpm | ||
| scripts | ||
| tests | ||
| udev | ||
| .editorconfig | ||
| .gitignore | ||
| .gitmodules | ||
| AUTHORS | ||
| CODE_OF_CONDUCT.md | ||
| COPYRIGHT | ||
| LICENSE | ||
| META | ||
| Makefile.am | ||
| NEWS | ||
| NOTICE | ||
| README.md | ||
| RELEASES.md | ||
| TEST | ||
| autogen.sh | ||
| configure.ac | ||
| copy-builtin | ||
| zfs.release.in | ||
README.md
OpenZFS is an advanced file system and volume manager which was originally developed for Solaris and is now maintained by the OpenZFS community. This repository contains the code for running OpenZFS on Linux and FreeBSD.
Official Resources
- Documentation - for using and developing this repo
- ZoL Site - Linux release info & links
- Mailing lists
- OpenZFS site - for conference videos and info on other platforms (illumos, OSX, Windows, etc)
Installation
Full documentation for installing OpenZFS on your favorite operating system can be found at the Getting Started Page.
Contribute & Develop
We have a separate document with contribution guidelines.
We have a Code of Conduct.
Release
OpenZFS is released under a CDDL license.
For more details see the NOTICE, LICENSE and COPYRIGHT files; UCRL-CODE-235197
Supported Kernels
- The
METAfile contains the officially recognized supported Linux kernel versions. - Supported FreeBSD versions are any supported branches and releases starting from 12.2-RELEASE.